Hi guys , i have been busy again with drawing and 3D printing.
This time it's a diesel hammer D62-22 3D printed , I made 3 versions in 1:50 scale.
1 : Is the basic model with no guides , so it does not fit on any device.
It is intended as load on a truck or in a crane , or as a piece in a diorama.
Also usable for scratch builders who want to make their own guides for a custom lead.
2 : Is the model that is intended for the swinging lead it has a starter mechanism and guides for the swinging lead.
And of course a swinging box lead made from separate parts so you can make it the length you like.
3 : Is the model that is intended for the Weserhutte W180 from NZG.
Although i think it is a bit big for this crane it is much better than the original hammer.
Some basic skills with spray painting could be handy.
Not much else need to be done as spray painting.
Some hoses could be glued on later to give it a nice touch but it is not necessary.
For both models ( weserhutte , swinging lead ) there are 2 hats.
1 for a square pole 8MM and 1 for a pipe 12MM.
There is a square pole also but that could be easy self build as well.
Working on the 1:87 version , will be there in a week or so.
Everything can be found and ordered here :
Diesel hammer D62-22 3D printed .
Dieselhammer200 by
eef 7260, on Flickr
Dieselhammer201 by
eef 7260, on Flickr
Dieselhammer202 by
eef 7260, on Flickr
Dieselhammer203 by
eef 7260, on Flickr
Dieselhammer204 by
eef 7260, on Flickr
Dieselhammer205 by
eef 7260, on Flickr
Dieselhammer206 by
eef 7260, on Flickr
Dieselhammer207 by
eef 7260, on Flickr
Dieselhammer208 by
eef 7260, on Flickr
Dieselhammer209 by
eef 7260, on Flickr
***
Flickr American cranes group***
3D printed crane parts at I.materialise
